NGK Spark Plug Resistor Cover - XD05F. This one has a 102 degree bend, long style. For 12mm or 10mm thread spark plugs without the terminal nut. We recommend using non-resistor type spark plugs when using resistor caps on vintage Honda's.
Fits all Honda SOHC Fours.
- NGK spark plug resistor covers are the best protection against radio frequency interference
- Rubber waterproof boots to seal out the elements, so the engine won't cut out if it rains.
- For use with 7mm diameter plug wires
- Sold Individually
NGK Part Number: 8072
Replaced Honda Part: 30700-MC8-000
Installation tips:
Remove terminal nut before installing new spark plugs. It's screwed onto the top of the spark plug.
Put a light coating of anti-seize on the spark plug threading before installing. After all, you're threading a steel part into a aluminum engine case.
Don't over tighten the spark plug, 1/8 to 1/4 turn past finger tight.
When using the old spark plug wires, trim them back 1/4" - 1/2" to expose fresh wire, then using a pick type tool, fan out the wires before threading on the new resistor cover.
Twist on the new cover about 3 full turns and give it a tug to make sure it's snug.
Fits tons of bikes and many models used more than 1 type of cap. Check the part number and photo to see if it's what you need.
14 Reviews Hide Reviews Show Reviews
-
Ngk
Great product.
-
Exactly as described & good quality
Exactly as described & good quality
-
GL1100 spark plug caps - perfect replacement.
They are perfect replacements for the GL1100.
-
Parts
Exactly what I needed
-
Very Good
Very Good product and I recommend it.
-
Getting the right part
As always, getting the right part and as described from 4into1. The only place to shop for vintage bikes.
-
Great product
Best out there on the market and best price
-
Good quality
Good quality, fits Good and has decent water seals, however I miss the original white lettering of the NGK trademark
-
High Quality product
Most older bikes that come in my shop need new plug caps