Reproduction front or rear brake caliper rebuild kit for the Honda models listed with NISSHIN brake calipers.
Stock calipers have a tendency to become corroded and the piston can seize inside the caliper. If you're rebuilding your rear caliper it might be time for a fresh rebuild kit, especially if the original piston is pitted. Ride safe and brake with confidence!
NOTE: Check VIN # range for your model listed below, brake calipers changed from year to year.
Kit Includes:
Piston x1: 45107-410-006 - Diameter 38mm / Height 35mm
Piston Seal x1
Piston Dust Seal x1
Dust Seal Clip x1
Pin Boot x2
Bleeder Cap x1
Installation Tips:
Make sure to thoroughly clean the channel in the caliper that holds the seal, if there is any built up grease or dirt it will not allow the seal to sit properly which will affect the pistons ability to engage and retract.
The darker side of the piston with the indented ridge faces the brake pad.
Use brake grease between the piston and the pad but do not allow any grease or brake fluid to come in contact with brake pads. (this kit does not come with pads)
Fits Honda:
CB750F Super Sport - 1977-1979 - Front (2 sets needed) Rear (1 set needed)
CB750F Super Sport - 1980 - VIN# RC04-2100003 TO RC04-2116089 - Front (2 sets needed)
CB900C Custom - 1980 - Front (2 sets needed)
CBX Super Sport - 1979 - Rear (1 set needed)
GL1000 Gold Wing - 1978 - Front (2 sets needed)
