Reproduction front or rear brake caliper rebuild kit for the Honda models listed. Replace the piston seal when replacing your piston or after cleaning the stock piston. Forms a tight seal to prevent brake fluid from seeping past the piston.
Kit Includes:
Piston x1: 45107-415-006 - Diameter 43mm / Height 41mm
Piston Seal x1
Piston Dust Seal x1
Dust Seal Clip x1
Pin Boot x2
Bleeder Cap x1
Installation Tips:
Make sure to thoroughly clean the channel in the caliper that holds the seal, if there is any built up grease or dirt it will not allow the seal to sit properly which will affect the pistons ability to engage and retract.
The darker side of the piston with the indented ridge faces the brake pad.
Use brake grease between the piston and the pad but do not allow any grease or brake fluid to come in contact with brake pads. (this kit does not come with pads)
Fits Honda:
CX500 - 1978-1979 - Front (1 set needed)
CX500C Custom - 1979-1981 - Front (1 set needed)
CX500D Deluxe - 1979-1981 - Front (1 set needed)
CB900C Custom - 1980 - Rear (1 set needed)
CB900C Custom - 1981 - Front (2 sets needed) - Rear (1 set needed)
CBX Super Sport - 1979-1980 - Front (2 sets needed)
GL1000 Gold Wing - 1979 - Front (2 sets needed)
