Reproduction front or rear brake caliper rebuild kit for the Honda models listed.
Stock calipers have a tendency to become corroded and the piston can seize inside the caliper. If you're rebuilding your front caliper it might be time for a fresh rebuild kit, especially if the original piston is pitted. Ride safe and brake with confidence!
NOTE: Check VIN # range for your model listed below, brake calipers changed from year to year.
Kit Includes:
Piston x2: 45107-MA3-006 - Diameter 30mm / Height 35mm
Piston Seal x2
Piston Dust Seal x2
Pin Boot A x2
Pin Boot B x1
Bleeder Cap x1
Installation Tips:
Make sure to thoroughly clean the channel in the caliper that holds the seal, if there is any built up grease or dirt it will not allow the seal to sit properly which will affect the pistons ability to engage and retract.
The darker side of the piston with the indented ridge faces the brake pad.
Use brake grease between the piston and the pad but do not allow any grease or brake fluid to come in contact with brake pads. (this kit does not come with pads)
Fits Honda:
CB400T Hawk - 1981 - Front (1 set needed)
CM400C Custom - 1981 - Front (1 set needed)
CB450SC Nighthawk - 1986 - Front (1 set needed)
CMX450C Rebel - 1986-1987 - Front (1 set needed)
CX500C Custom - 1982 - Front (1 set needed)
CX500TC Turbo - 1982 - Front (2 sets needed) - Rear (1 set needed)
FT500 Ascot - 1982-1983 - Front (1 set needed)
GB500 Tourist Trophy - 1989-1990 - Front (1 set needed)
GL500 Silver Wing - 1981-1982 - Front (1 set needed)
GL500I Silver Wing Interstate - 1981-1982 - Front (2 sets needed)
VF500F Interceptor - 1984-1986 - Front (2 sets needed) - Rear (1 set needed)
CB650SC Nighthawk - 1983-1985 - Front (2 sets needed)
CX650T Turbo - 1983 - Rear (1 set needed)
GL650 Silver Wing - 1983 - Front (2 sets needed)
GL650I Silver Wing Interstate - 1983 - Front (2 sets needed)
VF700C Magna - 1984-1986 - Front (2 sets needed)
VF700C Magna - 1987 - Front (1 set needed)
VF700S Sabre - 1984-1985 - Front (2 sets needed)
CB750F Super Sport - 1981-1982 - Front (2 sets needed)
CB750K Four - 1982 (to frame CM30151) - Front (1 set needed)
CB750SC Nighthawk - 1982-1983 - Front (2 sets needed)
VF750C V45 Magna - 1982-1983 - Front (2 sets needed)
VF750C V45 Magna - 1988 - Front (1 set needed)
VT800C Shadow - 1988 - Front (1 set needed)
CB900C Custom - 1982 - Front (2 sets needed) - Rear (1 set needed)
CB900F Super Sport - 1981-1982 - Front (2 sets needed)
CB1000C Custom - 1983 - Front (2 sets needed) - Rear (1 set needed)
CBX Super Sport - 1981-1982 - Front (2 sets needed)
GL1100 Gold Wing - 1982 - Front (2 sets needed) - Rear (1 set needed)
GL1100A Gold Wing Aspencade - 1982 - Front (2 sets needed) - Rear (1 set needed)
GL1100I Gold Wing Interstate - 1982 - Front (2 sets needed) - Rear (1 set needed)
VF1100C V65 Magna - 1983-1986 - Rear (1 set needed)
VF1100S V65 Sabre - 1984-1985 - Rear (1 set needed)
VT1100C Shadow - 1985-1990 - Front (2 sets needed)
VT1100C Shadow - 1992-1993 - Front (1 set needed)
1 Review Hide Reviews Show Reviews
-
Purchased For Honda GL500
Good quality product of all items listed. Purchased for brake caliper rebuild. Purchased same and glad I did as one piston on each caliper was seized. Replacement pistons were required. Would recommend to GL500 owners