Genuine Honda Kick Starter Oil Seal - 18X29X7 - 91204-286-003 - CB/CL350K/360 CB400/500K/550/750

Genuine Honda Oil Seal 18X29X7. This seal was commonly used on right crankcase, it's the seal that goes around the kick starter. On the CB750A it was used on the left crankcase cover. Clean everything thoroughly and install the new seal with a socket with the same outer diameter as the seal or a seal driver. Make sure to push it in evenly. An oil tight engine puts the mind at ease and it keeps the engine lubricated!

Honda Part: 91204-286-003
Also Replaces Honda Part Numbers: 91202-KK0-003, 91202-KK0-005, 91204-286-005

Note: The models that didn't use this seal on the crankcase cover state the location it was used. The clutch cover on the CB750F/K used this seal for the kick starter output shaft.

Fits Honda:

XL75 - 1977-1979
XR75 - 1977-1978
XR80 - 1979-1984
XL80S - 1980-1985
XR80R - 1985-2003
XL100S - 1979-1985
XR100 - 1981-1984
XR100R - 1985-2003
XL175 - 1973-1978
CM185T Twinstar - 1978-1979
ATC200X - 1986 - VIN# JH3TB052-GK500056 TO JH3TB052-GK519186
CM200T Twinstar - 1980-1982
XR200R - 1984-1985
CR250M - 1973-1976
CR250R - 1978-1980
MR250 - 1976
MT250 - 1974-1976
TL250 Trials - 1975-1976
XL250K - 1972-1976
XL250R - 1982-1987
XL250S - 1978-1981
XR250 - 1979-1980
XR250L - 1991-1996
XR250R - 1981-2004
CB350K - 1968-1973
CB350G - 1973
CL350K Scrambler - 1968-1973
SL350K - 1969-1971
XL350K - 1974-1978
CB360K - 1974
CB360G - 1974
CB360T - 1975-1976
CJ360T - 1976-1977
CL360K Scrambler - 1974-1975
CB400A Hawk Hondamatic - 1978
CB400TI Hawk I - 1978-1979
CB400TII Hawk II - 1978-1979
CM400A Hondamatic - 1979-1981
CM400T - 1979
XR400R - 1996-1998
CM450A - 1982-1983
XL500S - 1979-1981
XR500 - 1979-1980
XR500R - 1981-1982
CB500K - 1971-1973
CB550K - 1974-1978
CB550F Super Sport - 1975-1977
CB750A Hondamatic - 1976-1978 - Starting Motor + Left Side Cover
CB750F Super Sport - 1975-1978 - Clutch Cover
CB750K - 1969-1978 - Clutch Cover
GL1000 Goldwing - 1975-1977
GL1000LTD Gold Wing Limited - 1976