Ignition Coil - Honda CT70 Trail 1969-1982

High quality ignition coil for the Honda CT70 Trail. It comes with a 90 degree spark plug cap installed for a quick and easy installation! Get that CT70 sparking again and back on the trails!

We also carry an ignition tune up kit here.

Specifications:

Mounting Stud Spacing: 56mm (2.2") (measured center to center)
Overall Width: 97mm (3.8")
Coil Length: 62mm (2.5")
High Tension Wire Length: 22" (spark plug wire)
Low Tension Wire Length: 10" (male bullet terminals)
Primary Resistance: 1.5 ohms +/- 10%
Secondary Resistance: 9.8k ohms +/- 10%
Voltage: 6V

Replaces Honda part number: 30530-126-921

Note: May also work with the C70M, CA100, CA102, CA105T, CA110, CA200, CM91, CT90, CT200, P50, S65 but wiring modification may be necessary to connect the points and condenser properly.

Note: This coil is self grounding. If adapting it to work with other models, in some cases you would have to mount the coil to ground, and in some cases you would have to isolate it from ground (it should NOT be mounted to metal). It depends on how you will be wiring in your condenser. 

Note: 6 volt power source connects to the black wire coming off the coil (male bullet connector). The wire from the points should connect to ground, where the coil is mounted.

Fits Honda:

CT70HK Trail - 1970-1973
CT70K Trail - 1969-1975
CT70 Trail - 1976-1982