Reproduction 12V Honda ignition coils and spark plug caps for the CB/CL450K and CB500T. Use this kit with your points ignition or electronic ignition. Fan out the spark plug wires before twisting on the caps.
Specifications:
Spark plug wire is 19" long
Mounting holes are approximately 80mm (3.15") apart. (measured from the center of each hole)
6.5" blue wire with dual female bullet connector
5.25" black/white line wire with male bullet connector
Overall Outer Diameter: 48.6mm at the widest point.
Primary Windings: 5 ohms
Black wire connects to 12V power, blue goes to the points and condenser. Kit also includes 2 120 degree spark plug caps.
Replaces Honda Part Number: 30500-292-672 (Coil assembly for: CB450K1-K7, CL450K, CB500T)
Fits Honda:
CB450K - 1965-1974
CL450K Scrambler - 1968-1974
CB500T - 1975-1976
4 Reviews Hide Reviews Show Reviews
-
Coils, caps and wires
I ordered this product for my 1976 Honda CB 500 twin. Fit perfectly with no modifications. Both points lead wires are blue. Got some yellow electrical tape to indicate the opposite coil. Plenty of spark plug wire to play with and get everything in position. Resistor caps Worked great! Don't forget to use the proper spark plug (ngk b8es) non resistant type. Weak spark if you use a resistor cap with a resistor plug (ngk br8es). Great product everything worked perfectly!
-
coils
fit up very well works great
-
Honda IGNITION COILS AND CAPS
the coils and caps on my Honda were original and starting to misfire and act up in general so I ordered a set from 4into1. They were easy to replace, reasonably priced and solved the misfire problem. The bike starts and runs smoothly now, Thanks 4into1
-
Item was a perfect match for my bike.
Item was great, bought two to swap them both at the same time. Full removal and install time was less than 1 hour. Swapped my plugs at the same time to give me an end to end replacement.
