This seal is found on the rear case cover on the models listed below. Not to be confused with the clutch cover seal.
This is a high quality new seal produced in Taiwan. When it comes to rubber parts and seals it's generally better to install a brand new part instead of using a NOS part which has hardened due to age.
A great way to isolate where an oil leak is coming from is to clean the area thoroughly, put some baby powder on the area you suspect it's coming from, then go for a 5-10 minute ride. Voila, the leaks location is revealed! Clean everything thoroughly and install the new seal with a deep socket with the same outer diameter as the seal or a seal driver. Make sure to push it in evenly. An oil tight engine puts the mind at ease and it keeps the engine lubricated!
*Sometimes a light coating of three-bond or hondabond is necessary to keep the seal from popping back out if you have a recurring problem. We have Hondabond available.
Replaces Honda Part Numbers: 91204-371-005
Dimensions: 25X54X7
Material: NBR (Nitrile)
Fits Honda:
GL1000 Gold Wing - 1975-1979
GL1000LTD Gold Wing Limited Edition - 1976
GL1100 Gold Wing - 1980-1983
GL1100A Gold Wing - 1982-1983
GL1100I Gold Wing Interstate - 1981-1983
GL1200 Gold Wing - 1984
GL1200A Gold Wing - 1984-1985
GL1200I Gold Wing Interstate - 1984-1985
GL1200L Gold Wing Limited Edition - 1985
