CLOSEOUT ITEM - RETURNS NOT ACCEPTED
Regulator rectifier for the Honda GL1200 Gold Wing. Battery not charging? Might be time to replace your rectifier regulator. Unlike many other units, this is designed to work with lead acid based, gel and lithium batteries. The battery must be fully charged and in perfect working order before installing a new regulator rectifier.
This unit has a very consistent output and runs cooler than the original part due to the modern heat sink. It is also made to handle the high output from the stator in the GL1200 fuel injected models so you can ride with confidence!
We also carry a different version with a single plug for the standard, Aspencade and Interstate GL1200 models here.
All units are tested prior to shipping for quality assurance. Includes industry-leading 1 year warranty.
Specifications:
Dimensions: 82mm length x 95mm width x 30mm height
Mounting bolt spacing: 58mm - 83mm (Measured center to center)
Includes 2 mounting bolts: M6 x 25mm (1mm thread pitch)
Note: Corroded / loose / damaged wiring is a common cause for charging system issues, make sure all connections are clean and secure. If the stock connector is brittle or melted and the terminals are corroded, it's best to replace them before installing the new part. This unit might not mount where the stock part was, check dimensions above.
Note: It is strongly recommended to isolate the charging issue prior to replacing the regulator / rectifier. With a bad battery, stator or wiring issues, a new RR will not charge the battery. A faulty stator or wiring can cause damage to the RR.
Fits Honda:
GL1200L Gold Wing Limited Edition - 1985
GL1200SE-i Gold Wing Aspencade SE-i - 1986
