Reproduction left side switch assembly for the CB550 and CB750, see fitment notes below. It's common for the turn signal switch to crack and break. Corrosion and cracked solder joints on the stock switch make for an unreliable and unsafe switch! Pick up a new one and ride with confidence!
There is a locator pin built into the switch like the stock ones, if you're using aftermarket handlebars, just drill a hole in the bars before mounting the switch. This switch is designed so the wires route INSIDE the handlebars. If you are installing this on a model that uses the plastic 6 pin connector, you will have to remove the connector to route the wires through the handlebar. The connector can be removed easily by bending the small tab on each spade terminal.
This switch assembly will fit on many of the Honda CB's, check your wiring harness and make sure the connectors will work. If you have non-stock handlebars, check the wire harness length.
- Wire harness is 23" long. (measured to the end of the shortest wire)
- 4 Male Bullet connectors - white, dark blue, brown/white line, brown/blue line, brown/white line
- 2 Female Bullet connectors - orange/white line, blue/white line
- Male 6 pin plastic plug - green, light blue, orange, brown, grey
- Includes 7 spare male bullet terminals
- Horn, high & low beam, L & R turn signal functions
- Threaded hole for 10mm mirror
- Has a hole for the stop switch
Honda Part Number: 35200-404-671 (also replaces 35200-374-671, 35250-341-678)
We also carry the Genuine Honda stop switch that fits the perch and the right side switch assembly.
Fits Honda:
CB550K - 1977-1978
CB750K - 1977-1978
Fits Honda (Remove plastic plug and female bullet connectors - Use supplied male bullet terminals)
CB550F Super Sport - 1975-1977
CB550K - 1974-1976
CB750K - 1973-1976
CB750F Super Sport - 1975-1976
can also be used on other years and models...
12 Reviews Hide Reviews Show Reviews
-
Left control switch
Kind of difficult to stuff the wires thru the handle bar. Had to remove the connector first but, it's in, on and works!
-
Left hand switch assembly
Great quality, excellent value, would highly recommend
-
Excellent!
Full rebuild of 78 CB750k using over 90% parts from 4 into 1. Excellent product, amazing, service, and value. I will be duplicating this review in some of the parts I purchased. This is 100% from a true customer! Love 4 into 1!
-
Turn switch has some friction
Everything worked well. The turn signal switch does feel a little rough as I slide it, but it still work perfectly fine
-
Product was great
Prosuct works perfectly.
-
GREAT REPRO 's.
The wiring deal is a little untold...
-
Looks original but modifications needed
The switch looks good. Great match to the original. However all the wires are too short and I had to splice in the original wires to make it the correct length. Happy overall but it was a bit of work I didn't expect. 1975 CB550F
-
Switch Assembly
Excellent reproduction of the original, looks great & works a treat, I would recommend to anybody
-
Not the Best - But Useable
Strippied 1 of 3 holes but likely my own fault as I tend to overtighten. Be judicious and you'll be fine. Also, use a proper crimper when replacing the female connectors to male. Makes a big difference.
