Reproduction Throttle / Switch Assembly - 35300-323-671 - Honda CB500 CB750

Reproduction Honda throttle / starter / kill switch assembly for the CB500 four and the CB750. It's common for the starter button's on these bikes to wear out due to arcing or break for various reasons. This is an easy part to replace if your wires aren't running through the handlebars, if they are, it requires removing the handlebars and feeding the wires through. Electric start sure is nice to have when it's reliable!

If you are running aftermarket handlebars check to make sure the 29.5" wire harness is long enough. This switch is designed to have the wires run inside the handlebars, if you have aftermarket bars you'll have to drill a hole to route the wires through. There is a locator pin inside the switch similar to the stock switch. 

This switch assembly will fit on many of the Honda CB's, check your wiring harness and make sure the connectors will work or you can replace the bullet connectors with connectors that match your harness.

This switch is handy to have since you can turn the lights off to save on power consumption during daytime riding.

• Wire harness is 28.5" long.
• 6 Male Bullet connectors - yellow/red line, 2 black, brown/white line, white, blue
• 1 Female Bullet connector - black/white line.

Replaces Honda Part Number: 35300-323-671 (supersedes 35300-300-674)

Note: This could also be used on a 72-74 Honda CB350F four cylinder model, but it looks slightly different from the original switch and the wire harness length may be different.

Fits Honda:

CB500K (four) - 1971-1973
CB750K - 1971-1972