Shaped O-Ring Float Bowl Gaskets - Honda CB500/550 - Kawasaki KZ750

I ve tried other brands and they just don't work these work.

Fits great and no leaks.

Bought float bowl gasket for a 1977 CB550K and they fit well. Found out I needed some o rings also , so I bought the complete carb gasket set. Didn’t fit. Later I remembered that Honda model years would run over into the next year , sure enough mine is titled as a 77. But in fact is a 76. Might want to have a disclaimer to actual fit or better yet a serial number chart so customers can look up the correct fit for their Honda

These shaped o rings are the only way to go - they match the bowl perfectly CB550F 1976. I have rarely been able to reuse them, they become too big so they may not be very fuel resistant. I would like them to be a bit thicker in diameter but they do work well - doesn't leak at all after carb rebuild

very much better than the round gaskets you get with some kits. I will buy again when an application presents itself

better then round ones

These are the only gaskets to get, fitted like a glove with a smear of rubber grease and seal tight

If you need new float bowl gaskets, you've got to get these. They fit do easily, no need to deal with any trickery trying to get the round ones to stay put.

Fits perfectly in the slot. A lot better than fumbling around with the o-ring style ones.