Throttle / Switch Assembly - 35300-319-670 - Honda CB450 - 1971-1972

Reproduction Honda throttle / starter / kill switch assembly for the CB450 from 1971-1972. It's common for the starter button's on these bikes to wear out due to arcing or break for various reasons. This is an easy part to replace if your wires aren't running through the handlebars, if they are, it requires removing the handlebars and feeding the wires through. Electric start sure is nice to have when it's reliable!

This is for use with a single pull throttle cable. Not push pull.

If you are running aftermarket handlebars check to make sure the 29.5" wire harness is long enough. There is a locator pin built into the switch, just like the stock ones, if you're running aftermarket handlebars you'll need to remove the pin or you can drill a hole in your bars for the pin to fit into. Also note that these switches are made for use with stock bars where the wring runs through holes in the bars.

This switch assembly will fit on many of the Honda CB's, check your wiring harness and make sure the connectors will work or you can replace the bullet connectors with connectors that match your harness. This switch is handy to have since you can turn the lights off to save on power consumption during daytime riding.

• Wire harness is 29.5" long.
• 6 Male Bullet connectors - yellow/red line, 2 black, brown/white line, white, blue
• 1 Female Bullet connector - black/white line.

Replaces Honda Part Number: 35300-319-670

Note: This switch has a total of 7 wires, some of the stock switches had 9 wires. There is a solid yellow wire and a white/yellow stripe wire that isn't part of this switch.

Fits Honda: