Ultimate carburetor rebuild kit with floats for certain Honda CB350 & CL350 twins from 1970-1973. This is the most complete kit available for the 350 twins! Comes with everything shown. It even has both types of air mixture screws that were used. Check the list below for jets sizes. This kit comes with a shaped float bowl gasket and passage plug made of high quality Viton rubber so it will not swell after coming in contact with fuel.
NOTE: Be sure to check your carbs to see if this kit will work for your bike. This kit works with carburetor models 3D, 722A, 726A & 728A which were used on engine number 1065279 and later.
Includes 2 floats with pins, 2 diaphragms, and 2 carburetor rebuild kits. Made in Taiwan.
Each Carburetor Kit Includes:
Shaped Float Bowl Gasket (Much easier to install than a round o-ring)
Main Nozzle
Secondary Nozzle
Float Needle Valve & Seat
D20 Slide Needle, Clip & Spring
Air Adjustment Screw & Spring (Fits 3D carburetors - Does not fit all carburetor models)
Air Adjustment Screw, Spring, Washer & O-Ring
Secondary Main Jet #100 (Carb model 728A)
Secondary Main Jet #105 (Carb models 3D, 722A, 726A)
Secondary Main Jet #110 (optional if you are running aftermarket air filters / aftermarket exhaust)
Primary Main Jet #68 (Carb models 722A, 726A)
Primary Main Jet #70 (Carb models 3D, 728A)
Idle Jet #35
Slow Jet Passage Plug
Drain Screw With O-Ring
Fits Honda:
CB350K Twin - 1970-1973
CL350K Scrambler - 1970-1973
3 Reviews Hide Reviews Show Reviews
-
Ultimate Carburetor Rebuild Kit
Great rebuild kit, comes with everything needed. Good parts quality. Please check the floats as they didn't fit to my carbs' The '72 Honda CB250K is running again! Thanks.
-
Almost perfect
Great rebuild kit, I do recommend it. Only drawback is that the Air/Fuel screw O ring was too big to use, so I used my old one. That was the only flaw. All else: great. Bike is running really nice.
-
Almost frustrated
Very slow service from USPS, because package was missing about 2 month in California. Seller made request when informed by me. In product, there is some differences in dimensions compare to originals. Some too tight jet o-rings and loose jet tubes to carb body. O-ring in airscrew is also littlebit too large. Hope those do not give any troubles for engine running…
