Vesrah quality gasket set for Honda CB550. Made in Japan. Vesrah gaskets are equal to or better than the originals.
Vesrah Part Number: VG-155
Includes:
12329-323-000 - Breather Cover Gasket - x1
12391-323-000 - Cylinder Head Cover Gasket - x1
91302-001-020 - O-Ring 30.8mm - x12
91303-035-000 - O-Ring 11 x 2.5mm - x3
91319-323-000 - O-Ring 6 x 3mm - x4
91301-200-000 - O-Ring 10 x 1.6mm - x8
91301-323-000 - O-Ring 5 x 2.4mm - x2
91304-286-000 - O-Ring 61.8 x 2mm - x4
12251-374-005 - Cylinder Head Gasket - x1
12191-374-000 - Cylinder Base Gasket - x1
18291-390-000 - Exhaust Pipe Gasket - x4
12209-333-005 - Valve Stem Seal - x8
91305-323-000 - O-Ring 5.8 x 1.9mm - x1
11398-323-000 - Oil Pump Gasket - x1
30372-300-300 - Points Cover Gasket - x1
11394-390-306 - Crankcase Cover Gasket - x1
11691-323-000 - Alternator Cover Gasket - x1
31282-323-300 - Starter Motor Cover Gasket - x1
Fits Honda:
CB550F Super Sport - 1975-1977
CB550K - 1974-1978
5 Reviews Hide Reviews Show Reviews
-
Good fit
Good fit and good quality so far. Have not completed rebuild yet. It should include a diagram with descriptions for o-rings. I cannot ID all of them. It appears some are missing and I don't recognize others.
-
Leaking gaskets
Like Gene's post, I used this set to do my top end and have had to replace almost every easily replaceable rubber gasket including the oil pan gasket. The diameter is too small, very disappointing. I would look for Athena Brand gasket set either on Parts n More website or eBay.
-
Not a complete set
As others have said, does not come with the little pucks. That's fine, at least I was warned. However, my kit did not come with any o-rings for the oil pump, the three fittings for oil passages through the lower crank case, or the O-ring around the starter. Basically ever O-ring for the bottom end. Just note that you’ll need a lot more o-rings to do a full job and I couldn’t find some of them from 4into1.com. I ended up having to go somewhere else to complete the kit.
-
perfect kit
Perfect for my 74 cb550! The rubber seals will need to be purchased separately so do not this! Thanks!
-
Incomplete Gasket Set
Purchased this set to rebuild my 1975 Honda CB550F. The O-Rings are all quality rubber, although I lost one of the tiny oil port rings that goes between the block and head and had to use one of the old ones since any extras are not provided. The gaskets are all good but the head gasket does not align perfectly as the OEM. Note that you will also need to purchase the rubber pucks between the head and valve cover because they are not included in the set: Vesrah Sealing Rubber - AB-1001 - Honda CB500 CB550 CB650 CB750.