All Balls Front Or Rear Wheel Bearing & Seal Kit - 25-1072 - Honda 70cc-175cc

All Balls quality wheel bearing and seal kit for the Honda models listed below. Includes everything shown, 2 bearings & 3 seals.

All Balls Number: 25-1072
Bearing Number: 6301 (quantity 2)

Fits Honda Front Wheel:

MT50S (EURO) - 1993-1996
CT70 Trail 70 - 1969-1994
SL70K Motosport - 1971-1973
CR80R Elsinore - 1980-1982
CT90 Trail 90 - 1966-1979
XR100 - 1981-1984
CT110 Trail 110 - 1980-1986
CB125S - 1976-1985
CR125M Elsinore - 1974-1978
CT125 Trail 125 - 1977
GROM 125 - 2014-2015
MT125 Elsinore - 1975-1976
SL125K Motosport - 1971-1973
TL125 Trials - 1973-1976
XL125 - 1974-1978
MR175 Elsinore - 1976-1977

Fits Honda Rear Wheel:

CRM50R (EURO) - 1993-1996
MT50S (EURO) - 1993-1996
CRM75R (EURO) - 1993-1994
CR80R - 1980-1981

All Balls Installation Instructions:

Bearing Removal

Use a long punch (should have a good edge) Remove any Circlips or retainers. Insert the punch into the wheel and catch the edge of the bearing on the other side. Using a hammer, hit the punch and work around the entire circumference of the bearing. The bearing and seal will eventually be pushed out of the wheel hub. The second bearing can be removed using a punch, a long socket or other suitable driver. Note: The bearings will be damaged during the removal process and should not be reused. The hammer blows transmit their impact through the balls causing small flat spots, which will cause the bearing to quickly fail if reused. 

Inspection 

• Inner Spacer: Check the bore to make certain it is clean and the axle easily passes through it. Check each end for wear and burrs. The edges must be square to seat properly against the new bearings. If the old bearings failed it is a good idea to confirm that the center spacer has not been damaged. Make sure the inner space is the same length or slightly longer than the bearing stops in the hub or carrier. 
• Wheel Hub: Clean the hub, removing any dirt and corrosion. Make certain not to remove metal. This will adversely affect bearing fit. 
• Outer Wheel Spacers: Clean the outer wheel spacers and inspect them for wear on either end as well as wear on the outer surface where it makes contact with the seal. If the spacers are excessively worn they should be replaced. 

Bearing Installation 

• Note 1: Improper installation can cause bearing damage and dramatically reducing bearing life. 
• Note 2: Heating the wheel hub will cause the hub to expand slightly and will make bearing installation easier.