Deluxe tune up kit for the Honda CB350 & CL350 twins from 1970-1973. Comes with everything shown. This is a great kit for bringing a 350 twin back to life after it's sat for the last decade or more! The carburetor kits come with a shaped float bowl gasket made of high quality viton rubber so it will not swell after coming in contact with fuel. No oil filter is necessary since the twins use a centrifugal filtering system which just needs to be cleaned.
- Carburetor rebuild kit x2
- Left and Right Points
- Condensers
- B8ES NGK Spark Plug x2
- 90 Degree Spark Plug Cap x2
- Ignition Coil x2
Each Carburetor Kit Includes:
Shaped Float Bowl Gasket (Much easier to install than a round o-ring)
Main Nozzle
Secondary Nozzle
Float Needle Valve & Seat
D20 Slide Needle, Clip & Spring
Air Adjustment Screw & Spring (Fits 3D carburetors - Does not fit all carburetor models)
Air Adjustment Screw, Spring, Washer & O-Ring
Secondary Main Jet #100 (Carb model 728A)
Secondary Main Jet #105 (Carb models 3D, 722A, 726A)
Secondary Main Jet #110 (optional if you are running aftermarket air filters / aftermarket exhaust)
Primary Main Jet #68 (Carb models 722A, 726A)
Primary Main Jet #70 (Carb models 3D, 728A)
Idle Jet #35
Slow Jet Passage Plug
Drain Screw With O-Ring
NOTE: Be sure to check your carbs to see if this kit will work for your bike. This kit works with carburetor models 3D, 722A, 726A & 728A which were used on engine number 1065279 and later.
We also carry a pod filter set that fits the models below as well as primary, secondary and slow jets for all your re-jetting needs. This kit is also available without the coils.
Fits Honda:
CB350K Twin - 1970-1973
CL350K Scrambler - 1970-1973
