Dyna / Dynatek ignition kit with Magna coils for the Honda GL1000 Goldwing from 1975-1979. This is a great kit to modernize the stock ignition system!
The Dyna S Ignition System is a complete self-contained electronic ignition system built with the latest state-of-the-art engineering. This is the same ignition used by top racers over the past 2 decades. The Dyna S is completely housed behind the ignition cover and uses a magnetic rotor with the original spark advancer, so the factory advance curve is maintained.
NOTE: This ignition can be used with your stock coils or any coils over 3 ohms. Dynatek recommends the 5 ohm coils with this Dyna S ignition.
NOTE: The 2 output towers on the coils should point down and you may have to cut a small amount from the air filter intake for clearance. This is a minor modification and it's worth it for the high performance coils! If using this coil with a Dyna Ignition, the ballast resistor must be bypassed.
Comes with everything shown + instructions for the Dyna S and a one year manufacturer warranty on the Dyna ignition. Wires on the coils can be mounted on either terminal (no polarity + or - )
Installation instructions here.
Kit Includes:
- 2 Magna High Output Coils
- 4 Spark Plug Caps
- Copper Core Spark Plug Wires
- 1 Dyna S Electronic Ignition
Coil Specifications:
- Primary Resistance = 5 ohms
- Secondary Resistance = 17,500 ohms
- Mounting Holes = 90mm or 102mm (measured center to center)
- Mounting Posts = 13mm Width x 12mm Height
- Includes Hardware, wiring and boots shown in the photo.
Fits Honda:
GL1000 Goldwing - 1975-1979
