Reproduction rear tail light bracket for many of the 70's Yamaha motorcycles. This chrome bracket is ready to mount up to your rear fender and get that tail section looking like new again. Hardware and grommets are not included.
Replaces Yamaha part number: 341-84751-61-93
Upper tail light mounting hole spacing: 66mm (center to center)
Lower mounting hole spacing: 30mm (center to center)
Fits Yamaha:
AT1 125 -1971
AT1MX Motorcross -1971
AT2 125 -1972
AT3 125 -1973
CS3 200 -1971
CS5 200 -1972
CT1 175 -1971
CT2 175 -1972
CT3 175 -1973
DS7 250 -1972
DT100 - 1974-1976
DT175 - 1974-1976
DT1E 250 - 1971
DT1MX 250 - 1971
DT2 250 - 1972
DT250 - 1974-1976
DT3 250 - 1973
DT360 - 1974
DT400 - 1975-1976
G6S 80 - 1970-1971
G7S 80 - 1972
GT1 80 - 1973
GT80 - 1974-1976
GT80 MX - 1975
GTMX - 1973
HS1 90 - 1970-1971
HT1 90 - 1970-1971
LS2 100 - 1972
LT2 100 - 1972
LT3 100 - 1973
R5 350 - 1970
R5B 350 - 1971
R5C 350 - 1972
RD125 - 1975-1976
RD200 - 1974-1976
RD250 - 1974-1975
RD250 Street Series 250 - 1973
RD350 - 1974-1975
RD350 Street Series 350 - 1973
RD60 - 1974-1975
RD60 Street Series 60 - 1973
RS100 - 1975-1976
RT1 360 - 1970-1971
RT2 360 - 1972
RT3 360 - 1973
TX500 - 1974
TX500 Street Series - 1973
TX650 Twin - 1973-1974
TX750 Street Series - 1973
TX750 Twin - 1974
XS1 Twin 650 - 1970-1971
XS2 Street Twin 650 - 1972
XS500 - 1975
XS650 - 1975-1979
XS650 Twin - 1976
2 Reviews Hide Reviews Show Reviews
-
Tail lamp bracket
Very nice reproduction- the chrome is very slightly sketchy just like the original yamaha part
-
Dt250 Tail light bracket
I received the bracket in good time in the UK, it is of good quality, but. I have not yet got around to fitting it to the bike as that has now been fully stripped nut and bolt for restoration!
