Set of 2 new spark plug resistor cover replaces NGK's now discontinued LB05FP for the CB350 twin and most of Honda's other twin's from the 60's and 70's. This one has a 90 degree bend. For 14mm thread spark plugs without the terminal nut. Special rubber waterproof boot to seal out the elements. We recommend using non-resistor type spark plugs when using resistor caps on vintage Honda's.
- Rubber waterproof boots to seal out the elements, so the engine won't cut out if it rains.
- For use with 7mm diameter plug wires
- Fits all Honda Twins from the 60's and 70's plus a lot of single cylinder 4 strokes and 2 strokes
Replaces NGK Part Number: 8030
Replaces Honda Part Number: 30700-098-153
Installation tips:
Remove terminal nut before installing new spark plugs. It's screwed onto the top of the spark plug.
Put a light coating of anti-seize on the spark plug threading before installing. After all, you're threading a steel part into a aluminum engine case.
Don't over tighten the spark plug, 1/8 to 1/4 turn past finger tight.
When using the old spark plug wires, trim them back 1/4" - 1/2" to expose fresh wire, then using a pick type tool, fan out the wires before threading on the new resistor cover.
Twist on the new cover about 3 full turns and give it a tug to make sure it's snug.
Fits Honda:
CB72 Hawk 250 - 1961-1966
CB77 Super Hawk 305 - 1961-1968
CB350K - 1968-1973
CB350G - 1973
CL350K Scrambler - 1968-1973
SL350K - 1969-1973
CB360K - 1974
CB360G - 1974
CB360T - 1975-1976
CJ360T - 1976-1977
CL360K Scrambler - 1974-1975
