New spark plug resistor cover replaces NGK's now discontinued VB05F. This one has a 120 degree bend, long style. For 12mm or 10mm thread spark plugs without the terminal nut. We recommend using non-resistor type spark plugs when using resistor caps on vintage Honda's.
Fits all Honda SOHC Fours. They can also be used on the CB450K DOHC.
- Rubber waterproof boots to seal out the elements, so the engine won't cut out if it rains.
- For use with 7mm diameter plug wires
- Sold Individually
Replaces NGK Part Number: 8032
Installation tips:
Remove terminal nut before installing new spark plugs. It's screwed onto the top of the spark plug.
Put a light coating of anti-seize on the spark plug threading before installing. After all, you're threading a steel part into a aluminum engine case.
Don't over tighten the spark plug, 1/8 to 1/4 turn past finger tight.
When using the old spark plug wires, trim them back 1/4" - 1/2" to expose fresh wire, then using a pick type tool, fan out the wires before threading on the new resistor cover.
Twist on the new cover about 3 full turns and give it a tug to make sure it's snug.
Fits tons of bikes and many models used more than 1 type of cap. Check the part number and photo to see if it's what you need.
