Starter Solenoid with Regulator / Rectifier - Lithium Battery - Honda CB350/400/500/550/750

kr656.80
(No reviews yet) Write a Review
Availability:
Ships in 24 hours
Adding to cart… The item has been added

Reproduction starter solenoid switch and regulator / rectifier combo kit for the SOHC Honda CB models listed. Quality replacement parts to Keep your vintage Honda motorcycle's electrical system working properly. The Rectifier / Regulator Combo unit will replace both your old rectifier and regulator. And it is designed to work with lead acid based batteries, including Gel batteries as well as lithium batteries. You must have a fully charged battery in perfect working order before installing a new regulator rectifier. The starter solenoid comes with the rubber holder for mounting application.

Regulator / Rectifier Fetures:

  • 82mm Long x 30mm Tall x 80mm Wide
  • Mounting Hole Spacing: 66mm (measured center to center)

Starter Solenoid Fetures:

  • Height: 52mm (including posts)
  • O.D: 35mm (without rubber holder)
  • Mounting Posts: M6
  • Wire Length: 7" (Male bullet yellow/red line - Female bullet green/red line)

Installation Note: 

  • The white 5 wire connector on the Regulator / Rectifier plugs into the stock wiring harness, replacing the old rectifier. The 3 male spade connectors plug in where the old regulator connected.
  • Regulator / Rectifier combo will not mount where the old rectifier was, you must find a place to secure it after removing the stock regulator and rectifier. The body of the unit does not need to be grounded.
  • The regulator rectifier is not compatible with lithium batteries that require a constant set point voltage of 14 or higher.
  • Corroded / loose / damaged wiring is a very common cause for charging system issues, make sure all connections are clean and secure.
  • Coating the terminals and connectors with dielectric grease is a good preventative measure to prevent corrosion.
  • The regulator rectifier is not compatible with lithium batteries that require a constant set point voltage of 14 or higher.
  • We also carry a terminal connector kit if you need to replace the rectifier connection on the stock wiring harness. If the stock connector is brittle and the terminals are corroded, it's best to replace it.

Replacement for Honda Part Numbers: 31700-333-008, 31400-300-035, 35850-371-670, 35850-375-000, 35850-431-007, 35850-HB3-771, 35850-HB3-000, 35850-306-670

Fits Honda:

CB350F 350 Four (CB350F0) - 1972-1973
CB350F1 350 Four - 1974
CB400F Super Sport 400 Four - 1976-1977
CB400F Super Sport 400 Four (CB400F0) - 1975
CB500 500 Four (CB500K0) - 1971 - Need to replace female terminal and spade connectors
CB500K1 500 Four - 1972
CB500K2 500 Four - 1973
CB550F Super Sport 550 Four - 1976-1977
CB550F Super Sport 550 Four (CB550F0) - 1975
CB550K 550 Four - 1976-1978
CB550K 550 Four (CB550K0) - 1974
CB550K1 550 Four - 1975
CB750F 750 Super Sport - 1976-1978
CB750F 750 Super Sport (CB750F0) - 1975
CB750K 750 Four - 1976-1978
CB750K 750 Four (CB750K0) - 1969-1970
CB750K1 750 Four - 1971
CB750K2 750 Four - 1972
CB750K3 750 Four - 1973
CB750K4 750 Four - 1974
CB750K5 750 Four - 1975

Designed to work with 3 phase charging systems on pre-1979 Honda SOHC4's

Will also work on the CB750A Hondamatic 76-78 but the plastic plug must be removed and swapped for an 8-pin version