Top end gasket set for the Honda XR600R from 1988-2000. If you're doing an engine rebuild this is a great set to have on hand. The piston rings are for the stock bore.
ISO 9001 100% Non-asbestos gaskets
Installation Tips:
- Be very careful when installing the cylinder over new rings, it's helpful to have the proper tool to keep the rings compressed as you lower the cylinder over the pistons. Try to use only plastic tipped tools to prevent from scratching aluminum surfaces.
- The Letter stamped on the top two rings should be facing up when installing them and stagger the ring gaps according to the manual.
- All sealing surfaces for gaskets must be clean and flat to make a proper seal, sometimes non-hardening sealant is necessary.
Ring Order:
Top Compression Ring (silver outer rim)
Second Ring (black outer rim)
Bottom Rings (3 pieces - Spacer in the middle - 1 thin wiper ring on either side)
Fits Honda:
XR600R - 1988-2000
