Top end engine rebuild kit with pistons for the Honda CB750 from 1970-1976. Time to rebuild? If you're diving in and doing the top end, honing the cylinders and replacing engine gaskets, this is a great kit to have on hand!
Gasket Set Includes
12329-300-020 - Breather Cover Gasket - x1
12391-300-040 - Cylinder Head Cover Gasket - x1
91302-001-020 - O-Ring 30.8mm - x8
91305-323-000 - O-Ring 5.8 x 1.9mm - x4
91304-286-000 - O-Ring 61.8 x 2mm - x4
12251-300-004 - Cylinder Head Gasket - x1
12191-300-030 - Cylinder Base Gasket - x1
14592-300-000 - Cam Chain Tensioner Gasket - x1
18291-254-000 - Exhaust Gasket - x4
12209-300-003 - Valve Stem Seal - x8
31282-300-020 - Starter Motor Cover Gasket - x1
15135-300-010 - Oil Pump Gasket - x1
91318-300-013 - Sealing Rubber - x6
12115-300-000 - Cylinder Stud Gasket - x8
- Be very careful when installing the cylinder over new rings, it's helpful to have the proper tool to keep the rings compressed as you lower the cylinder over the pistons. Try to use only plastic tipped tools to prevent from scratching aluminum surfaces.
- The Letter stamped on the top two rings should be facing up when installing them and stagger the ring gaps according to the manual.
- All sealing surfaces for gaskets must be clean and flat to make a proper seal, sometimes non-hardening sealant is necessary.
Piston Ring Order:
Top Compression Ring (silver outer rim)
Second Ring (black outer rim)
Bottom Rings (3 pieces - Spacer in the middle - 1 thin ring on either side)
CB750K - 1970-1976