Carburetor repair or rebuild kits for the Honda CB750K models from 1972-1976. This is a complete set including 4 rebuild kits. Enough for 1 bike. We also have kits available individually.
Each Kit Includes:
Float bowl gasket
Top cover gasket
D17 slide needle and e-clip
2.0 float needle and seat
#110 main jet
#40 slow jet
air screw and spring
Additional parts, washers and o-rings as shown
Fits Honda:
CB750K - 1972-1976
4 Reviews Hide Reviews Show Reviews
-
Poor Quality Kits
Problems with these kits: 1) Of the 4 kits I purchased, one slow jet did not have the center machined/drilled out; it was completely blocked -- no fuel at idle. At low speed, before transition to the main fuel circuit, that cylinder was completely dead. I ended up cleaning the original slow jet and reinstalling to correct the issue. 2) The machining tolerance of the press fit slide needle seats in all four kits was so poor the seats were loose in their bores. I cleaned the originals and reinstalled them. Other than for gaskets and non-metering parts, I would not recommend these kits. Just clean and reuse your original slide needles, main jets and slow jets -- there should normally be very little wear on these parts. And the tolerances and fuel metering of the original Honda parts will be correct. The machining tolerance/quality of the Keyster kit is just too suspect.
-
O-rings
For the tube between the carburetors are not included, phenolic washers for needle is not included
-
Complete kit
Great price, fast shipping, and the assurance that it is made for my bike
-
Good Complete Kit
Bought this to restore the carbs on my CB750. Kit is very comprehensive, even include news vacuum plugs for your sync gauges.