Reproduction left and right handlebar switch assemblies for the Honda CB450K Super Sport from 1971 to 1972. It's common for the stock switches to wear and corrode from decades of use. Sometimes the stock wires become brittle and break easily, so pick up a new switch and get back on the road!
If you are running aftermarket handlebars check to make sure the wire harness is long enough. The throttle switch is designed for use with stock bars where the wring runs through holes in the bars, and the turn signal switch is designed so you can run the wires inside the bars or outside.
Note: May require modification to the wiring to fit. Check the terminals and wire colors listed and compare to the switch being replaced.
Turn Signal Switch Specifications:
- Wire harness overall length = 32"
- 4 Male Bullet connectors - green, blue, grey and orange
- Does not have a locator pin
Throttle Switch Specifications:
- Wire harness overall length = 29.5"
- 6 Male Bullet connectors - yellow/red line, 2 black, brown/white line, white, blue
- 1 Female Bullet connector - black/white line
- Locator pin built into the switch, just like the stock ones
- This switch has a total of 7 wires, some of the stock switches had 9 wires. There is a solid yellow wire and a white/yellow stripe wire that isn't part of this switch
Replacement for Honda Part Numbers: 35300-319-670, 35250-300-033
Fits Honda:
CB450K4 Super Sport 450 - 1971
CB450K5 Super Sport 450 - 1972
